FX-Sabers.com

The S.A.B.E.R. GUILD: Saber Manufacturers => Vader's Vault => Topic started by: WatchGeek on January 11, 2021, 01:02:48 PM

Title: Flex Kyber Edition - Charging Mode?
Post by: WatchGeek on January 11, 2021, 01:02:48 PM

Hi,

First time poster here.  I have a question regarding the Vader's Vault Graflex Kyber edition.  This saber uses a USB Type-C port for charging the battery and has a separate kill switch.  My question is: When charging, should the saber be "turned on" or in "deep sleep mode" (i.e., kill switch is activated).  Thanks.

Title: Re: Flex Kyber Edition - Charging Mode?
Post by: WatchGeek on January 11, 2021, 03:21:27 PM

Or...more of a general question.  For CFX boards, should they be "ON" or "sleep mode" for charging?

Title: Re: Flex Kyber Edition - Charging Mode?
Post by: Nemezis on January 12, 2021, 04:31:25 AM

When charging, your board must be disconnected from power source.
It's usually done by correctly wiring the recharge port.
It's also the reason of being the kill switch which physically isolate the board from power source.